• Beginner
  • about 40 min

Crochet Wreath Ornament (Easy Christmas Pattern)

A free, easy crochet wreath ornament: single crochet worked into a chain ring, then three back-loop rounds for a ridged texture. Exact counts and a ribbon bow.

Skill
Beginner
Finished size
Approximately 3.75 in (9.5 cm) across, with a center hole of about 1.75 in (4.5 cm), in worsted yarn. Size depends on yarn and tension; these are estimates, not measurements.
Gauge
Not critical. Firm, even single crochet keeps the ring flat.

Materials

  • Worsted weight (medium, #4) yarn in green — About 7 yd (6.5 m). Estimated, not measured.
  • Crochet hook — 4 mm (US G-6).
  • Narrow ribbon in red or gold — About 16 in (40 cm), for the bow and the hanging loop.
  • Stitch marker, yarn needle and scissors

Stitches used: chain (ch) · slip stitch (sl st) · single crochet (sc) · increase (2 stitches in one stitch) (inc) · back loop only (BLO)

Jump to pattern

A wreath is just a flat circle with a big hole in the middle, which makes it one of the most beginner-friendly Christmas ornaments. You work single crochet into a chain ring, then add three rounds in the back loops only. The unused front loops form ridges that look like layered greenery. A ribbon bow finishes it.

US/UK note: This pattern uses US terms. US single crochet (sc) is UK double crochet (dc).

Abbreviations

ch = chain · sl st = slip stitch · sc = single crochet (UK double crochet) · inc = 2 sc in the same stitch · BLO = back loop only · st(s) = stitch(es) · rep = repeat

Pattern notes

  • Rounds are joined with a sl st to the first sc, then ch 1. The ch 1 does not count as a stitch. Work the first sc of each round into the same stitch as the join.
  • In Round 1 you work over the chain ring: insert the hook through the center of the ring, not into the chains. Push the stitches together as you go so all 30 fit.
  • In Rounds 2–4, work every stitch in the back loop only: the loop farther from you.
  • Increases are staggered (in the middle of the repeat on Round 3) so the ring stays round.

Pattern

Foundation: Ch 24, sl st in the first ch to form a ring. Make sure the chain is not twisted.

Round 1: Ch 1, 30 sc in ring. Sl st to first sc. (30 sts)

Round 2: Ch 1, working in BLO, *sc in next 4 sts, inc in next st; rep from * 5 more times. Sl st to first sc. (36 sts)

Round 3: Ch 1, working in BLO, *sc in next 2 sts, inc in next st, sc in next 3 sts; rep from * 5 more times. Sl st to first sc. (42 sts)

Round 4: Ch 1, working in BLO, *sc in next 6 sts, inc in next st; rep from * 5 more times. Sl st to first sc. (48 sts)

Fasten off, leaving a 6 in (15 cm) tail.

Counts at a glance

Round Repeat (× 6) Stitch count
1 30 sc in ring 30
2 sc 4, inc 36
3 sc 2, inc, sc 3 42
4 sc 6, inc 48

Finishing

  1. Weave in both tails on the back, following the stitches, before you trim them.
  2. Cut 10 in (25 cm) of ribbon, tie it into a bow around the wreath over the join, and trim the ends at an angle.

Hanging loop

Thread 6 in (15 cm) of ribbon or yarn on a yarn needle, pass it under both loops of a stitch in Round 4 opposite the bow, and tie the ends together. Or loop the ribbon through the center hole and tie it at the top.

Stitch chart

Round chart of a flat ring: a circle of 24 chain ovals in the center, then four rings of single crochet X symbols with 30, 36, 42 and 48 stitches, and six V-shaped increases in each of the outer three rounds at positions that shift from round to round.
Rounds 1–4, read counter-clockwise. Oval = chain, X = single crochet, V = 2 sc in one stitch, dot = joining slip stitch. Rounds 2–4 are worked in the back loop only.

Chart key

  • chain (ch)
  • slip stitch (sl st) — UK: slip stitch (ss)
  • single crochet (sc) — UK: double crochet (dc)
  • increase (2 stitches in one stitch) (inc)

Rounds are read counter-clockwise from the center, starting at each round’s beginning chain.

Open the chart full size ↗

Common mistakes

  • Round 1 won’t fit 30 sc: the stitches are spread out. Slide them along the ring so they sit close together. Don’t add chains.
  • The ring twists into a figure eight: the foundation chain was twisted when you joined it. Undo the join and straighten the chain.
  • Wavy outer edge: too many stitches, or a loose hook. Recount, then try a smaller hook.
  • Cupping (bowl shape): too few stitches, or tight tension. Recount, then try a larger hook.
  • No ridges: you worked under both loops. BLO starts in Round 2.

Variations

  • Size: for a bigger wreath, add a Round 5 with *sc in next 3 sts, inc in next st, sc in next 4 sts; rep from * 5 more times (54 sts). For a smaller one, use DK yarn and a 3.5 mm hook.
  • Color: make Round 1 in dark green and Rounds 2–4 in a lighter green, or work Round 4 in white for a snowy edge.
  • Stiffening: a wreath in worsted single crochet usually holds its shape. If yours is floppy, you could use a commercial fabric stiffener. How to block and stiffen crochet compares the stiffeners and shows the steps.

FAQ

Can I make the wreath in a spiral instead?

Yes. Skip the joins and the ch 1, and move a stitch marker to the first stitch of each round. The counts stay the same.

Why work into a chain ring instead of a magic ring?

A magic ring closes up tight. A chain ring keeps a hole in the middle, and that hole is what makes it a wreath.

Can I add berries?

You can tie on small wooden or felt beads with the ribbon. Crocheted berries would need to be sewn on, and that isn’t covered here.

This page uses US crochet terms.